DIRECTIONS FOR USE:
For optimal results, install the rinse injection fitting as far back in the line from the rinse jets as possible, thus allowing the thorough mixing of the drying agent with the water supply before it emerges from the final rinse jets. The final rinse temperature should be maintained close to the 160oF (71oC) minimum possible, and should not exceed 185oF (85oC). Check the final rinse pressure and set it to the manufacturer’s recommended level. Also, inspect the final rinse for spray atomization. Adjust the rinse injector to feed the Power Dry drying agent solution at the required concentration to achieve the most rapid sheeting of water from the ware. Concentrations as low as 50 parts per million may be used, depending upon the hardness and total dissolved solids content of the water supply. When using POWERDRY in a hard or alkaline water area, it is recommended that the machine first be descaled with acid cleaners. The flatware, glasses, and china should also be briefly soaked (1-2 minutes) in a warm (100-120oF or 38 – 49o C) dilute (1 -2%) solution of an acid cleaner. This will remove any alkaline or hard water film deposits.

PACKAGING:
20L carboy

STORAGE & CONDITION
Store in a cool, dry, and well-ventilated place where temperatures do not exceed 30oC. Keep container tightly capped and in an upright position when not in use.

PRECAUTIONS
WARNING! CORROSIVE! MAY CAUSE SKIN IRRITATION.
KEEP OUT OF REACH OF CHILDREN. Avoid contact with eyes and skin. If eye contact occurs, rinse thoroughly with running water for a minimum of 20 minutes. If eye irritation persists, seek medical attention. If on skin, take off all contaminated clothing. Rinse skin immediately with plenty of water for at least 15 minutes. If swallowed and the patient is conscious, administer milk or water and call a physician immediately. Do not induce vomiting.